RHINO 1540 Manual del operador descargar pdf (Pagina 36)

OPERATION

1540 02/12 Operation Section 4-6

OPERATION

3.3 Tractor 3-Point Hitch

The tractor 3-point hitch must be rated to lift at least

1409 lbs. for the 8’ and 1529 lbs. for the 10’.

The 1540 can attach to tractor’s with either a CAT II

or III hitch. Refer to the tractor operator’s manual for

the category of the tractor used. If the hitch does

not conform to the ASABE CAT II or III dimensions,

the blade may not fit or raise properly. Consult an

authorized dealer for possible modification

procedures to mount nonconforming hitches.

Use the correct hitch pins for the hitch category

being used. For a Cat II hitch, 1-1/8” lower and a 1”

upper diameter hitch pins are used and Cat III

hitches require 1-7/16” lower and a 1-1/4” upper

diameter hitch pins.

CAT II Implement / Hitch Specification CAT III Implement/ Hitch Specification

Width from outside to outside A-frame.........32-3/8” Width from outside to outside A-frame ..................38”

Quick Hitch width inside lug to lug ..............33-5/8” Quick Hitch width inside lug to lug ..................39-1/4”

Height from bottom hitch pin to top pin .............. 19” Height from bottom hitch pin to top pin .................22”

Lower pin diameter ......................................1-1/18” Lower pin diameter..........................................1-7/16”

Upper pin diameter ............................................. 1” Upper pin diameter............................................1-1/4”

Lynch pin diameter........................................ 15/32” Lynch pin diameter...........................................15/32”

3.4 Front End Weight

A minimum of 20% total tractor weight must be maintained on the tractor front end at all times. Front end

weight is critical to maintain steering control and to prevent the tractor from rearing up while driving. If the

front end is too light, add weight until a minimum of 20% total weight is reached on the front tires. Front

weights and weight carriers can be purchased through an authorized tractor dealership. OPS-U- 0005

4. GETTING ON AND OFF THE TRACTOR

Before getting onto the tractor, the operator must read and completely understand the implement and tractor

operator manuals. If any part of either manual is not completely understood, consult an authorized dealer for

a complete explanation. OPS-U- 0007

Do not mount or dismount the Tractor while the tractor is moving. Mount

the Tractor only when the Tractor and all moving parts are completely

stopped.

(SG-12)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Sin comentarios

RHINO 1540 Manual del operador Pagina 36