RHINO RC456 Manual del operador descargar pdf (Pagina 14)

Your M&W Rake may come unassembled or partially assembled as required using the following instructions.

1. Install the Sector Support (8) on the 3-Point Base (1). Insert the 3-Point Cap (17) and secure in place with a

capscrew and locknut through the cap and base. Lock the support plate in position on the 3-point base with a 3-point

pin (10) secured with a Hairpin Cotter (9). See Illustration 1.

ASSEMBLY

Illustration 1

Illustration 2

2. Install the Stand (3) on the 3-point linkage and secure with a spring clip. See illustration 2.

3. With the assembly laying on the ground so the sector plate's lower socket is facing up, insert the Floating Arm

(26) into the socket and secure with a Socket Secure Pin (15), two Flatwashers (32) and two Cotter Pins (14). Install

the Upper Spring Mount (20) behind the third point using a capscrew and nut. Lock the floating arm in position by

installing the Lock Plate (27) on the bottom of the arm and secure with a Hairpin Cotter (4). See Illustration 2.

4. Install the two Extension Springs (21) in the upper spring mount and then connect the other ends of the springs

to the Lower Spring Mount (23). Secure the lower spring mount to the floating arm using a capscrew and nut. Use

the center hole for the time being. After final assembly, move the lower mount if necessary to allow the rake to "float"

in operation. See Illustration 2.

CAUTION: Make sure the machine is supported as the main frame and wheel arms are installed to prevent

the machine from falling.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Sin comentarios

RHINO RC456 Manual del operador Pagina 14